Setup Step 5: Programme the Remote Transmitter
Note: The Transmitter is factory set to mode 1. The mode of the Remote Transmitter can be changed to fit your type or style of training.
To change the mode:
- Referring to the table in your manual for your model, adjust the Intensity Dial to the mode you want to use.
- Turn the Remote Transmitter over and remove the belt clip (if attached).
- With a pen, depress and release the mode button. When the mode button is pressed, the Transmitter Indicator Light will be solid in colour. When it is released, it will flash the mode selected.
For example, if Mode 2 is desired, adjust the Intensity Dial to Level 2. Once the Mode button has been depressed, the Transmitter Indicator Light will be solid, and once the Mode button is released, the Transmitter Indicator Light will flash 2 times. However, if you select the highest mode, the light will remain solid in color once the mode button is released.
Note: Continuous Stimulation will transmit for no more than 8 continuous seconds no matter how long the button is pressed. To reactivate, release and repress the button.
TO MANUALLY PROGRAM THE REMOTE TRANSMITTER’S ID CODE:
- Turn the intensity dial to the highest level (7/8/9), flip the toggle switch up, and then press and release the mode button on the back of your Remote Transmitter. This does not change the mode, so the current mode will still be active after the ID change is complete.
- Once the mode button is released, the green indicator light will illuminate and stay on for 15 seconds.
- While the green light is on, turn the intensity dial to select the 1st digit of the ID, using 1-7/8/9, and then press and release the side button. The green light will flash rapidly confirming selection.
- Again, while the green light is on, turn the intensity dial to select the 2nd digit of the ID, using 1-7/8/9, and then press and release the side button. The green light will flash rapidly confirming selection. The 2nd digit is optional, and if not desired, just wait until the green light turns off and refrain from pressing the side button.
- At the end of 15 seconds, or after the second press of the side button, the green light will turn off and the ID/frequency of the unit will be updated. At this point, the unit will be in the same mode it was in prior to setting the ID.
- Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter. See Step 6 below.
- NOTE: If you press the side button only once (skipping Step 4) the ID is still a two digit ID. The left digit is defaulted to 1. For example, if you selected 6 in Step 3 and pressed the button only once, the ID you get will be 16.
To return the unit to the factory ID either remove the battery or follow these steps:
- Turn the intensity dial to level 7/8/9, flip the toggle switch up, and then press and release the mode button on the back of your Remote Transmitter. This does not change the mode, so the current mode will still be active after the ID change is complete.
- Do not press any buttons and wait until the green indicator light turns off.
- You will now need to match the Collar Receiver to the Remote Transmitter. See Step 6 below.
