Using the Test Light Tool
- Turn the Collar Receiver off.
- Loosen the Contact Points with pliers.
- Bend the leads around the base of each Contact Point.
- Hand tighten the Contact Points, making sure that the leads stay in contact with the base of each Contact Point.
- Turn the Collar Receiver on.
- Press the Continuous Stimulation button on the Remote Transmitter. The Test Light will flash. At higher intensity levels, the Test Light will flash brighter.
- Remove the Test Light and hand-tighten the Contact Points. Be careful: over-tightening can damage the Contact Points.
- Save the Test Light for future testing. Note: If the Test Light does not flash, recharge or replace the battery and re-test. If Test Light still does not flash, contact the Customer Care Center at 1-800-732-0144.
Products related to this Support Topic:
Register Your Product
Get the most out of your warranty by registering your product.
Warranty & Return Info
Read about our warranty and return policies.
