Support Topic

Support Topic
#

Navigate:

#

Setup Step 7: Program the Collar Receiver for Multiple Dog Operation

Additional SportDOG™ Add-A-Dog® receiver(s) must be purchased to train additional dogs.

TWO OR THREE DOG OPERATION

  1. With the toggle switch on your Remote Transmitter in the up position, program the Remote Transmitter to mode 3, 4, 5, 6 or 8.
  2. Program the first Collar Receiver.
    • Turn the Collar Receiver off.
    • Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin its normal flashing. If this occurs, start over and repeat from 1.
    • After the Receiver Indicator Light has turned off, release the On/Off Button.
    • Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 2-3 feet from each other. If the Receiver Indicator Light does not flash 5 times, start over and repeat from 1.
  3. Program the second Collar Receiver using step 2 above, but using the Lower Button in place of the Upper Button.
  4. Program the third Collar Receiver using step 2 above, but using the Side Button in place of the Lower Button.

SIX DOG OPERATION
Program the Remote Transmitter to mode 5 or 6.

For six dog operation repeat above steps 2-4 with the toggle switch in the up position for dogs 1, 2, and 3. Then flip the toggle switch to the down position, and repeat above steps 2-4 for dogs 4, 5, and 6.

Products related to this Support Topic:
Gear The Way You'd Design It

Close