Support Topic

Support Topic
#

Navigate:

#

Setup Step 1: Prepare the Remote Transmitter

  1. Remove the panel from the side opposite of the knob and toggle switch. Note: The screws have been “captured” to allow them to stay in the panel once they have been loosened.
  2. Connect the battery to the 9-volt battery connector.
  3. Insert 9-volt battery and secure the panel.
  4. Make sure the wires are in the housing before securing the panel to the case. This will allow the transmitter to be consistently waterproof.
Products related to this Support Topic:
Gear The Way You'd Design It

Close